Greenheck PGD1000W00, Справочное руководство

Страница: 21 / 40

Microprocessor Controller for MUA 21
®
Menu
The Advanced Setpoints Menus allows the user to view and modify network
settings. The
service password (1000)
is required to make changes.
Control Variables
Advanced
Advanced Setpoints
c
.
p
co b
oard
a
ddress
This screen will appear with or without a network protocol provided with the unit.
This screen allows the user to configure the IP setting for BMS and/or when
the Web User Interface will be utilized. The controller may have a DHCP server-
assigned address or a manually-assigned static IP address. Factory settings are
shown in the screen to the left.
The Network Settings Menus allows the user to view and modify network
settings. The
service password (1000) is required to make changes.
Control Variables
Advanced
Network Settings
bac
neT
ip c
onFig
This screen will appear if the unit is set for BACnet IP and allows the user to set
the device and port settings.
u
noccupied
u
niT
o
peraTion
Possible unoccupied unit operation methods include:
• Unit Off
• Night Setback Cycle
• Recirculation with Unoccupied Setpoints
• Normal Operation with Unoccupied Setpoints
m
orning
w
arm
u
p and
c
ool
d
own
This screen will appear when the unit has a recirculating air damper installed. The
user can enable morning warm up, morning cool down, and set the duration for
the sequence.
o
Verride
h
eaTing
When the heating control is in the manual mode, use the arrow buttons to vary the
heating output.
o
Verride
e
conomizer
c
onTrol
When the heating control is in the manual mode, use the arrow buttons to vary the
output of the economizer ramp. This value may have an effect on the modulating
outside air damper position.
o
Verride
e
lecTric
h
eaT
When This screen only appears if the unit is equipped with electric post heat.
Electric heater percentage is directly proportional to the 0 – 10 VDC output signal.
m
odbus
Tcp s
laVe
This screen will appear if the unit is set for Modbus TCP and allows the user to set
device ID number.