Green Power CC1200-LPG, Руководство пользователя

Страница: 17 / 31

16
Connecting Electrical Loads
Let the engine stabilize and warm up for a few minutes after starting.
1. Plug in and turn on Circuit Breaker from “OFF” to “ON” position.
2. Turn on the desired electrical loads.
ƽ
DO NOT overload the generator.
ƽ
DO NOT use parallel with any other generators.
ƽ
Connection to the household electrical system must be made by a qualified electrician.
Stopping the Engine
1. Turn off and unplug all electrical loads. Never start or stop the generator with electrical devices
plugged in or turned on.
2. Let the generator run at no-load for several minutes to stabilize.
3. Turn the Engine Switch to the “Off” position.
4. Turn off the Main gas valve .
Do Not Overload Generator Capacity
Follow these simple steps to calculate the running and starting watts necessary for your purposes.
1. Select the electrical devices you plan on running at the same time.
2. Total the running watts of these items.
This is the amount of power you need to keep your items running.
3. Identify the highest starting wattage of all devices identified in step 1. Add this number to the
number calculated in step 2. Surge wattage is the extra burst of power needed to start some electric
driven equipment. Following the steps listed under “Power Management” will guarantee that only
one device will be starting at a time.
Power Management
Use the following formula to convert voltage and amperage to watts:
Volts × Amps = Watts
To prolong the life of your generator and attached devices, follow these steps to add electrical load:
1. Start the generator with no electrical load attached.
2. Allow the engine to run for several minutes to stabilize.
3. Plug in and turn on the first item. It is best to attach the item with the largest load first.
4. Allow the engine to stabilize.
5. Plug in and turn on the next item.
6. Allow the engine to stabilize.
7. Repeat steps 5-6 for each additional item.
Note:
Never exceed the generator capacity when adding loads.
WARNING