Green-Go Quad 4-wire, Быстрый старт

Страница: 9 / 13

__________________________________________________________________________________
Green-GO Quad 4-wire – Quick Start Guide
Set up Port Options
In the Options menu generic port set up is done. You can set up active channel priority and
cue/call volumes
Options
à
Set up port specific settings
Active Time
à
Set the time for a channel to be active after the last audio
activity. Range is from 0.5 to 45.0 seconds.
Tone
à
Set the level of the audio signal used for Alert, Cue, Connection
Status and Battery status. Range is MAX, -1dB to -48dB, MUTE.
Priority Dim
à
Set Attenuation of a lower priority channel if a higher priority
channel becomes active. Range is 0dB to -24db, MUTE.
Direct Priority
à
Set priority for direct channels; Low / Normal / High
Direct Volume
à
Set volume for direct channels. Range is 12db to -36dB, MUTE.
AutoTalk
à
Enable AutoTalk on channel 1 through 32 or turn it off.
When AutoTalk is activated, available audio will be sent to the selected
channel if no other sends are active.
Cue Mode
à
Set up the way the port responds to Cues.
Normal
à
the port does not reply to a incoming call
Auto answer
à
the port automatically replies with a Hold to a call
Ignore
à
the port ignores incoming calls
Set up the connection type of a 4-wire port
Connection
à
Set up the connection for this 4-wire port
Local connection
à
Set up this port as a normal Green-Go device in a local
network.
Remote connection
à
Set up this port as the passive side of a bridge connection.
Password à Set up a password for this connection. The password
needs to be identical on both sides of the connection.
and is always 8 characters long.
Generate Password
à
Automatically generate a random 8-character password
Local Port
à
Set up a TCP port for the connection. This port needs to
be the same on both sides of the connection. A different
and free port needs to be used for each connection
SndBuf
à
Set up the size of the audio packages being sent from
this port. A connection with high jitter in latency needs a
larger Buffer
RecvBuf
à
Set up the size of the buffer for the incoming audio
packages. A connection with high jitter in latency needs a
larger Buffer
Save
à
Save all changes made on this port connection, This will
cause a reboot of the device.
Cancel
à
Discard all changes made on this port connection