HOW TO ASSEMBLE
1
Fit two Vent Covers to the patterned face of the Right
Side Wall each using an M6x30mm screw, a standard
washer, a 25mm washer and a nylock nut.. Tighten the
nuts until the vents can rotate using gentle pressure.
They should not spin freely.
The Left Side Wall has vent slots, to ensure the chickens
have some fresh air at all times.
2
Fit the Small and Large Curved Door Retainer, and the
Small and Large Straight Door Retainer to the smooth
(inside) side of the Front Wall using 30mm and 40mm
Screws, Standard Washers, and Nylock Nuts.
These pieces form a recess into which the door fits when
closed, to make the door resistant to fox attack.
3
Fit the Small Clevis Pin into the hole in the Metal Door
from behind, and secure it using a washer and split ring.
This can be a little awkward. We find that holding the split
ring open by inserting a flat-bladed screwdriver between
the rings can make this task easier. But please mind your
fingers!
4
Place the Metal Door in position, and secure it with a
20mm screw, two Standard Washers, a 25mm Washer
and a Nylock Nut. Tighten the Nylock Nut until the door
can just rotate freely.
5
Fit both Side Walls to the Base using Pi Clips. Ensure that
the Double-hole lugs are at the front. Then fit the Roof
Support and the Lower Back Wall between the two side
walls using Pi Clips.
NOTE: The Base may be fitted either way up (we
recommend patterned side upwards).
6
Fit the Front Wall (patterned face outermost) to the end
with the double-hole lugs using Pi Clips.
NOTE: If you have purchased a Leg Set, the Front Leg
Extensions should be fitted at this stage. If you have
purchased a Wheel Set, the Wheel Bar should be
assembled and fitted at this stage.
Printed on recycled paper
© green frog designs limited 2010
Page 6 of 9
