Maintenance
DactyScan84c
Operator’s Manual
Rev. 1.0 July 2012
14
7 Maintenance
The DACTYSCAN84C device does not require any particular maintenance.
However, particular attention must be dedicated to cleaning the unit and
surface scanners.
WARNING
:
Cleaning must be carried out with the device OFF and
disconnected from the Personal Computer.
7.1 Cleaning of the casing
Clean with a soft cloth moistened with water and dry any excess water.
WARNING
:
Do not use solvents, alcohol, ammonia or domestic
cleaning products as they contain substances that
could damage the acquisition surface of the device.
7.2 Cleaning of the scanner
For normal functioning, the acquisition surface of the scanner need not be
perfectly clean as a slight film of dust, grease or moisture is compensated
electronically; it is advisable to clean the acquisition surface of the scanner only
in the case of evident signs of dirt or if highlighted by the diagnostics of the
device.
For routine cleaning of the scanner, use the specific Cleaning Accessories Kit
provided.
Proceed as follows:
1.
Take a tissue for cleaning the acquisition surface of the scanner.
2.
Check the acquisition surface of the scanner for any particles of dust or
other substances that could scratch the acquisition surface during
cleaning. Remove the particles by blowing on the scanner or using the
dry tissue, delicately cleaning the glass surface.
3.
Moisten the tissue with the acquisition surface cleaning solution, clean
without rubbing too hard, removing all traces of dust and grease.
4.
Dry any excess liquid.
