Gree R1, Руководство по обслуживанию

Страница: 36 / 53

Service Manual
Technical Information
33
* Note: Only for models with heating function.
1
On/Off button
Press this button to turn on the unit. Press this button again to turn off the unit.
*
5
Swing button
Press this button to set up & down swing angle.
AUTO COOL DRY
2
Mode button
Each time you press this button, a mode is selected in a sequence that goes from AUTO, COOL, DRY, FAN, and HEAT *,
as the following:
FAN HEAT
*
6
Sleep button
Under Cool or Heat mode, press this button to turn on Sleep function. Press this button again to cancel Sleep function. Under
Fan , Auto and Dry modes, this function is unavailable.
When setting Timer On or Timer Off, press " + " or " - " button to adjust the time.
3
Fan button
This button is used for setting Fan Speed in the sequence that goes from AUTO, ,
, to , then back to Auto.
Note: Fan speed under dry mode is low speed.
(Temperature can’t be adjusted under auto mode)
4
+ / - button
. e r u t a r e p m e t t e s e s a e r c e d / e s a e r c n i o t n o tt u b - / + s s e r P
8
●
●
I Feel button
Under ON status, press this button to set timer OFF; Under OFF status, press this button to set timer ON.
Press this button to start I FEEL function and " " will be displayed on the remote controller. After this function is set, the remote
controller will send the detected ambient temperature to the controller and the unit will automatically adjust the indoor temperature
according to the detected temperature. Press this button again to close I FEEL function and " " will disappear. When I FEEL
function is turned on,the remote controller should be put within the area where indoor unit can receive the signal sent by the remote
controller.
9
Light button
Press this button to
If “H1” is displayed on the remote controller while it’s not operated by the professional person/after-sales person, it belongs to the
misoperation.
Please operate it as below to cancel it.Under the OFF status of remote controller, hold the Mode button for 5s to cancel “H1” display.
Note:
● If remote controller displays “H1”, it belongs to the normal function reminder. If the unit is defrosting under heating mode, it
operates according to H1 defrosting mode. “H1” won’t be displayed on the panel of indoor unit;
● Once you set H1 mode, if you turn off unit by remote controller, H1 will display 3 times on the remote controller and then
disappear;
● Also, when you set H1 mode, when you change to heating mode, H1 will display 3 times on the remote controller and then
disappear.
turn on the display's light and press this button again to turn off the display's
light.
7
Timer button
Press this button once and the characters of HOUR ON (OFF) will flash to be displayed. Meanwhile, press " " button or " "
button to adjust timer setting (time will change quickly if holding " + " o r - " " button). Timer setting range is 0.5~24hours.
Press this button again to confirm timer setting and the characters of HOUR ON (OFF)will stop flashing.
If the characters are flashing but you haven’t press timer button,timer setting status will be quit after 5s.If timer is confirmer,
press this button again to cancel timer.
+
-