17
Technical Information
Service Manual
and Dry
AUTO
COOL
DRY
FAN
HEAT(Only for models with heating function.)
5.SWING button
Press this button to turn on up&down air swing.
Press this button, you can see indoor set temperature, indoor ambient temperature on indoor unit’s display. The setting on remote
controller is selected circularly as below:
Note:
Outdoor temperature display is not available for some models. At that time, indoor unit receives " " signal, while it displays
indoor set temperature.
8.Turbo button
Under COOL or HEAT mode, press this button to activate / deactivate the Turbo function.
10.Timer button
● Under ON status, press this button to set timer OFF; Under OFF status, press this button to set timer ON.
● Press this button once and the characters of HOUR ON (OFF) will flash to be displayed. Meanwhile, press " " button or " "
button to adjust timer setting (time will change quickly if holding " " or " " button). Time setting range is 0.5~24hours.
Press this button again to confirm timer setting and the characters of HOUR ON (OFF)will stop flashing.
If the characters are flashing but you haven’t press timer button,timer setting status will be quit after 5s.If timer is confirmer,
press this button again to cancel timer.
Press this button to turn on the unit. Press this button again to turn off the unit.
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL, DRY, FAN, and HEAT *,
as the following:
This button is used for setting Fan Speed in the sequence that goes from AUTO, , to , then back to Auto.
Press button to increase/decreaseset temperature. In AUTO mode,set temperature is not adjustable.
When setting Timer On or Timer Off, press "▲" or " " button to adjust the time.
* Note:Fan speed under dry mode is low speed.
▲ / ▲
▲ / ▲
▲
no display
Not applicable for this unit.
9.
Press this button to start I FEEL function and " " will be displayed on the remote controller. After this function is set, the remote
controller will send the detected ambient temperature to the controller and the unit will automatically adjust the indoor temperature
according to the detected temperature. Press this button again to close I FEEL function and " " will disappear. When I FEEL
function is turned on, the remote controller should be put within the area where indoor unit can receive the signal sent by the
remote controller.
▲
▲
▲
▲
