Gree GWH09AKC-K6DNA1A/I, Руководство пользователя

Страница: 18 / 46

Introduction for buttons on remote controller
Sleep 1 Cooling mode: under sleep status and after operation
for 1h, the temperature of the master unit will increase 1
℃ ,
then 2
℃
after 2h, after that, the unit will be operated at the set
temperature. Heating mode: under sleep status and after oper-
ation for 1h, the set temperature will decrease, then decrease
2
℃
after 2h, after that, the unit will be operated at the set
temperature.
Sleep 2 is the sleep temperature curve preset based on the
system.
Sleep 3 is the sleep curve setting under DIY sleep mode:
(1) Under Sleep 3 mode, long press “U&D FIXED ANGLE”
button to enter personalized sleep setting status, as the fig
shown:
Display the
set temperature
SLEEP button
In Cool or Heat mode, press this button and the unit will work
in the following sequence:
14
Display the
set time
I SENSE
button
OFF
SMART : the unit will judge based on the body sensing device,
body temperature, indoor temperature and the operation data
to enter different air supply modes including airflow blowing to
(2) Adjust “-” or “+” button to change the corresponding set
temperature, after that, press “U&D FIXED ANGLE” button for
confirmation to set temperature for the next hour, until tempe-
rature setting for the next 8h is finished. If sleep curve setting is
completed, at this time, the remote controller will display again.
(3) If not pressing any buttons in 10 seconds, the remote
controller will exit sleep curve setting status automatically and
restore the original display. During setting process, if pressing
“ON/OFF”, “Timer”, “Sleep” or other modes, it will exit the sleep
curve setting as well.
Sleep 4 is the afternoon nap mode. The temperature will be
changed automatically according to afternoon nap status.
If re-energizing the unit after power off, sleep mode will be
cancelled acquiescently; if micro sense function is not activat-
ed, when starting the sleep function, quiet fan speed will be
started automatically.