１６
１．
２．
４．
５．
６．
７．
８．
１．
２．
３．
４．
５．
６．
３．
Indoor Unit Installation Position Selection
Important Notices
Basic Requirements For Installation Position
１．
２．
３．
●
●
●
●
●
●
The unit installation work must be done by qualified personnel according to the
local
rules and this manual.
Before installating, please contact with local authorized maintenance center, if u
nit is
not installed by the authorized maintenance center, the malfunction may not so
lved,
due to discommodious contacts.
When removing the unit to the other place, please firstly contact with the author
ized
Maintenance Center in the local area.
Install in the following place may cause malfunction. If it is unavoidable, ple
ase
contact with service center:
Place where strong heat sources, vapors, flammable gas or volatile objects are
emitted.
Place where high-frequency waves are generated by radio equipment, welders a
nd
medical equipment.
Place where a lot of salinities such as coast exists.
Place where the oil (machine oil) is contained in the air.
Place where a sulfured gas such as the hot spring zones is generated.
Other place with special circumstance.
●
Avoid a location where is humid such as laundry or swimming pool.
The appliance must be positioned so that the plug is accessible.
４．
The appliance shall be installed in accordance with national wiring regulations.
５．
（ ）
（ ）
７．
８．
９．
The air intake and outlet vent should be far from the obstruction, make sure that the air
can be blown through the whole room.
Select a position where the condensing water can be easily drained out, and the place
is easily connected for outdoor unit.
Select a location where children can not reach.
Select the place where is strong enough to withstand the full weight and vibration of
the unit. And will not increase noise.
Be sure to leave enough space to allow access for routine maintenance. The height of the
installed location should be 230cm or more from the floor.
Select a place about 1m or more away from TVset or any other electric appliances.
Select a place where the filter can be easily taken out.
Make sure that the indoor unit installation should accord with installation dimension
diagram requirements.
on page 18
Outdoor Unit Installation Position Selection
Select a location from which noise and outflow air emitted by unit will not inconvenience
neighbors, animals, plants.
Select a location where there should be sufficient ventilation.
Select a location where there should be no obstructions cover the intake and outlet vent.
The location should be able to withstand the full weight and vibration of the outdoor unit
and permit safe installation.
Select a dry place, but do not expose under the direct sunlight or strong wind.
Make sure that the outdoor unit installation dimension should accord with installation
dimension diagram, convenient for maintenance, repair.
on page 17
The height difference of connecting the tubing should within 5m, the length of connecting
tubing should within 10m.
Select a place where it is out of reach for the children.
Select a place where will not block the passage and do not influence the city appearance.
Installation service- Notices for installation
.
