●
●
This function is applicable to partial of models.
●
This function is only available for some models.
1. Press the back side of remote controller marked
2.
3. Reinstall the cover of battery box.
signal sender
battery
reinstall
remove
Cover of battery box
●
●
●
●
●
●
●
WiFi button
Replacement of batteries
in remote controller
Light function
Introduction for buttons on
Under switch-on or switch-off state, you may hold
"+"and "FAN" buttons simultaneously to set the lamp
on or off and send the code. After being energized
the lamp is defaulted on.
with “ ”, as shown in the fig, and then push out
the cover of
battery box along the arrow direction.
Replace two 7# (AAA 1.5V) dry batteries, and make
sure the position of "+" polar and "-" polar are
correct.
As the signal will be interfered in the room with electronic
fluorescent lamp, conversion fluorescent lamp or wirel-
ess phone, please get closer to the air conditioner when
Function introduction for
remote controller
button for the third time to quit health and scaven-
ging functions simultaneously. Press the button for
the fourth time to start health function; LCD display
" ". Press this button again to repeat the operat-
ion above.
combination buttons
Temperature display switchover function
Under OFF status, press "-" and "Mode" buttons
simultaneously to switch temperature display betw-
een °C and °F
using the remote controller.
Replace new batteries of the same model when replace
ment is required.
When you don’t use remote controller for a long time,
please take out the batteries.
The batteries contain materials, which are hazardous
to the environment; they must be removed from the
appliance before it is scrapped and that they are
disposed of safely.
Do not ingest battery, Chemical Burn Hazard;
Keep new and used batteries away from children.
If the battery compartment does not close securely,
stop using the product and keep it away from children.
If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate
medical attention.
The distance between signal sender and receiving
window should be no more than 8m, and there should
be no obstacles between them.
Notice
●
How to turn on WiFi
：
Press " WiFi " button to turn
on WiFi function.
How to turn off WiFi
：
Hold " WiFi " button for 5s to
turn off WiFi function.
Under off status, press "MODE" and " WiFi " bu-
ttons simultaneously for 1s, WiFi module will res-
tore factory settings.
When WiFi function is turned on, " WiFi " icon will
be displayed on the remote controller; when WiFi
function is turned off, " WiFi " icon will disappear.
