5
© Copyright, GREE Canada, 2021
© Copyright, GREE Canada, 2021
CAUTION!
1) For some models, the power supply cord with this Air Conditioner contains a current detection
device designed to reduce the risk of fire. Please refer to the section “Operation of Current
Device” for details. In the event that the power supply cord is damaged, it cannot be repaired.
It must be replaced with a cord from the Product Manufacturer.
!
WARNING - FOR YOUR SAFETY
1) Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any
other appliance.
2) Avoid fire hazard or electric shock. Do not use an extension cord or an adaptor plug.
Do not remove any prong from the power cord.
!
ELECTRICAL INFORMATION
1) Be sure the electrical service is adequate for the model you have chosen. This information can be
found on the serial plate, which is located on the side of the cabinet and behind the grille.
2) Be sure the Air Conditioner is properly grounded. To minimize shock and fire hazards, proper
grounding is important. The power cord is equipped with a three-prong grounding plug for
protection against shock hazards.
3) Air Conditioner must be used in a properly grounded wall receptacle. If the wall receptacle you
intend to use is not adequately grounded or protected by a time delay fuse or circuit breaker, have
a qualified electrician install the proper receptacle.
4) Ensure the receptacle is accessible after the unit installation.
5) Do not run Air Conditioner without side protective cover in place. This could result in mechanical
damage within the air conditioner.
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG.
!
POWER SUPPLY CORD
With current detection device only.
The power supply cord contains a current device that senses damage to the
power cord. To test your power supply cord, do the following:
1) Plug in the Air Conditioner.
2) The power supply cord will have 2 buttons on the plug head. Press the TEST button, you will notice a
click as the RESET button pops out.
3) Press the RESET button, again you will notice a click as the button engages.
4) The power supply cord is now supplying electricity to the unit. On some products this is also
indicated by a light on the plug head.
NOTES:
1) Do not use this device to turn the unit on or off.
2) Always make sure the RESET button is pushed in for correct operation.
3) The power supply must be replaced if it fails reset when either the TEST button is pushed, or it
cannot be reset. A new one can be obtained from the product manufacturer.
4) If power supply cord is damaged, it cannot be repaired. It MUST be replaced by one obtained from
the product manufacturer.
SAFETY PRECAUTIONS
