10
3/4” Screws
Sash Lock
6
1
MOUNTING HARDWARE
Qty
Tools Needed:
Phillips Screw Driver
Drill (if plot holes are needed)
Frame Lock, Sash Lock, and Foam Seal
Installation
1. Drive 3/4” screws into the top of the accordi on panel
frame and the top rail to securely attach the window
air conditioner to the lower sash. (See FIG. 9/10)
2.To secure the lower sash into place, use the sash lock
and a 3/4” screw as shown below (See FIG. 11)
3.For added insulation, cut the supplied insulation foam to
the width of the window. In sert the foam between the
window sashes to prevent air and objects from getting
into the room.
(See FIG. 12)
Removing the Air Conditioner from the
Window
Drain water
1.Turn the air conditioner off, and disconnect the power
cord.
2.Remove the sash seal from between windows, and
unscrew sash lock.
3.Remove the screws installed through the frame and
frame lock.
4.Close (slide) the side panels into frame.
5.Keeping a firm grip on air conditioner, raise the sash
and carefully “rock” air conditioner backward to drain
any condensate water in base of unit. Be careful not to
spill any remaining water while lifting unit from window.
6.Store parts WITH the air conditioner in the box
To get the maximum cooling efficiency , the air conditioner is
designed to splash the condensate on the condenser coil. If the
splashing sound annoys you, you can provide an outside drain by
using the following procedure, which may however cause a small
loss of performance.
1. The air conditioner have the drainage gasket-FIG a.
2. Remove the drainage gasket from the body base plate- FIG b.
FIG.9
FIG. 10
FIG.12
FIG.11
FIG.a
FIG.b
