Gree GIS409AC, Руководство пользователя

Страница: 24 / 28

Condensate drainage of outdoor unit ( for
heat
ing only)
in the outdoor unit can be properly discharged by drainage
pipe .
Installation method:set the drain connection in Φ25 hole of the
chassis has been installed and then connect drainage pipe
be properly discharged
Chassis
Drain
connection
22
●
●
Install outdoor unit
Electric wiring
NOTE:
Wrong wiring may cause spare parts malfunction.
After the cable fixed, make sure there should be a free space between the connection
and connection and fixing place on the lead wire.
Handle
N(1) 2 3
Air purging and leakage test
3.
4.
5.
1.
2.
Disassemble the handle on the outdoor unit right side plate.
Take off wire clamp. Connect and fix power connect
cord to terminal of line bank. Wiring should fit that of
Fix the power connection cable with wire clamp,
then connect the corresponding
Ensure wire has been fixed well.
Install the handle.
connector.
5
-1.0 X 10 pa
(-76cmHg)
.
10
Fig.
1. Connect charging hose of manifold valve to charge end of low pressure
valve (both high/low pressure valves must be tightly shut).
2. Connect joint of charging hose to vacuum pump.
3. Fully open handle handle of Lo manifold valve.
4. Open the vacuum pump to evacuate. At the beginning, slightly
loosen joint nut of low pressure valve to check if there
is air coming inside. (If noise of vacuum pump has
been changed, the reading of multimeter is 0) Then
tighten the nut.
5. Keep evacuating for more than 15mins and make
sure the reading of multi-meter is
6. Fully open high/low pressure valves.
7. Remove charging hose from charging end of low pressure valve.
8. Tighten bonnet of low-pressure valve. (As shown in Fig.10)
Liquid pipe
Gas pipe Valve
cap
Vacuum
gauge
Vacuum pump
yellow-
green
blue black brown
indoor unit.
The condensate and defrosting water formed during heating
with drain nozzle,so that condensate and defrosting water can