11
Technical Information
Service Manual
1
2
3
4
5
6
Speed Indicator
Timer Indicator
Filter Cleaning
Indicator
Dehumidify Mode
Indicator
Bucket Full
Indicator
Display Window
Wind Direction Indicator
Fan
Mode
Wind
Direc
Humidity
Timer
High Med Low
Timer ON/OFF
Smart Cont Quiet Dry
Water Full
Swing
Fixed
Angle
Filter Clean
Notes:1.Water bucker must be correctly installed for operation.
2.Do not remove the bucket while unit is in operation.
3.If you want to use drain hose to drain water away, please install the hose according to section "Drainage method".
4.Each time pressing the effective button on the control panel will give out a "beep" sound.
simultaneously.
(1) ON/OFF Button
(2) Fan Button
Press Fan button can set high, medium or low fan speed. When thecorresponding indicator is on, it indicates the current fan speed
has been set.
(3) Timer Button
Press Timer button to set timer on or timer off. The timer can be set in 1h increment among 0-24h with each press of Timer button.
If hold the Timer button, time will increase rapidly circularly. After timer is set, time will be displayed for 5s and timer indicator ill be on.
(4) Humidity Button
Press Humidity button to set your required humidity. If hold Humidity button, humidity can be set in 10% increment among
30%-80% circularly. After that, the set humidity will be displayed for 5s.
(5) Mode Button
Press Mode button can set 4 kinds of dehumidify mode - Smart, Cont, Quiet and Dry.
●
If smart indicator is on, it indicates the unit enters into smart mode. The unit will intelligently select the comfortable humidity for
human according to current temperature.
●
If cont indicator is on, it indicates the unit enter into continuous dehumidify mode. The unit will always dehumidify only until the
humidity is decreased to the inapplicable humidity of human.
●
If the quiet indicator is on, the unit enter into quiet mode.The unit will intelligently select the comfortable humidity for human
according to current temperature. The unit will operate at the fan speed whose noise is the lowest. The fan speed can't be adjusted.
●
If the dry indicator is on, the unit enters into dry mode. After clothes are dried, room humidity will be kept at certain range to
prevent mildew. Under dry mode, fan speed and humidity can't be adjusted.
Note:
●
Under smart mode and quiet mode, if room humidity is lower than set humidity, or lower than the defaulted comfortable temperature,
the unit will stop dehumidifying.
●
Under dry mode and cont mode, the humidity can't be adjusted. Under dry mode and quiet mode, fan speed can't be adjusted.
(5) Wind Direc Button
indicator is on, the horizontal louver begins to swing; when Fixed Angle light is on, the horizontal louver stays at current position.
GDN40AW-K3EBA1A