CASSET TE B SERIES
OWNERS MANUAL - INDOOR UNIT
|
19
OPERATION OF REMOTE CONTROLLER (Continued)
NOTE
• During this procedure, if no button is pressed within
10 seconds, remote controller will automatically exit
the sleep curve setting and resume original display.
If ON/OFF, SLEEP, COOLING or HEATING button
is pressed during the setting or inquiry procedure,
remote controller will also exit the sleep curve
setting.
Press this button to turn off display light on indoor unit.
“ “ icon on remote controller disappears.
Press this button again to turn on display light. “ “ icon
is displayed.
Press this button to see the indoor set temperature on
the unit’s display. The setting on remote controller is
selected circularly as below:
NOTE
• Under status, you can set T-OFF or T-ON simultane-
ously.
• Before setting T-ON or T-OFF, please set the clock.
• After starting T-ON or T-OFF, set to “circulating”
mode.
• Your unit will be turned on or turned off according
to setting. ON/OFF button has no effect on setting.
If you don’ t need this function, please use remote
controller to cancel it.
Press this button to start I FEEL function and “ “ will be
displayed on the remote controller. When set, the remote
controller will send the detected ambient temperature
to the controller and the unit will automatically adjust
the indoor temperature according to the detected
temperature. Press this button again to cancel I FEEL
function and “ “ will disappear.
• Put the remote controller near the user when this
function is set. Avoid putting the remote controller
near an object of high or low temperature. When
I FEEL function is turned on, the remote controller
should be put where the indoor unit can receive the
signal sent by the remote controller.
Press this button to set clock time. “ “ icon on remote
controller will blink. Press “ “ or “ “ button within 5s
to set clock time. Pressing the “ “ or “ “ button, clock
time will increase or decrease 1 min. If you hold “ “ or “
“ button for longer than 2s the time will change rapidly.
Release this button when reaching your required time.
Press “CLOCK” button to confirm the time. “ “ icon
stops blinking.
NOTE
• This is a 24 hour clock.
• A delay of more than 5s in setting the ON and OFF
times will cancel the set-up and you will have to
start over. Operation for TIMER ON/TIMER OFF is
the same.
Under COOL or HEAT mode, press this button to start
up sleep function. “ “ icon is displayed on remote
controller. Press this button again to cancel sleep
function and “ “ icon will disappear.
