8
42000 Rev C 8-26-13
Thermostat control
Your unit contains a 9 Step thermostat-controlled heater ranging from 32-93 degrees F. If room
temperature is too high, turn the thermostat knob counter-clockwise direction; If you need to turn on the
heater, you can turn the thermostat knob clockwise.
To Reset the Heater
Your heater includes a protection system that shuts off the heater if it overheats for any reason:
1) Turn unit to the OFF position.
2) Unplug unit and wait 5 minutes.
3) Plug in again and turn on.
●
Remote control functions
Note: The fireplace Main Power Switch must be switched ON in order for the Remote Control to
function.
Note
：
If all light features are turned off and heater is turned on, the heater indicator light will remain lit. If other
light effects are turned on, the heater indicator light will turn off after a short period of time.
In order to protect the product from overheating, there is an 8 second delay when turning on the heater;
also there is 8s delay when turning off the heater fan.
SYMBOL
TITLE
FUNCTION
POWER
The Power button will put the fireplace in a standby
mode. This will turn off all functions at once but will
hold the settings in memory. Except Heater function,
by pressing the button again the unit will turn on at the
same settings.
FLAME
By pressing the FLAME button, the unit will cycle
through four flame effects.
EMBER
BED
By pressing the EMBER BED button, the unit will
cycle through five flame effects.
DOWN
LIGHT
By pressing the downlight button the unit will cycle
through two effects including OFF and ON setting.
HEATER
Press once for low heater setting (Pilot lights
illuminated
●○
).
Press again for high setting. ( Pilot lights illuminated
●●
)
Pressing a third time turns heat off. ( Pilot lights
illuminated
○○
).
NOTE: This remote control uses 1 CR2032 Lithium lon button cell battery (Included). Never
dispose of batteries in fire, except under conditions of controlled incineration. (Failure to
observe this precaution may result in an explosion.)
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
