7
42000 Rev C 8-26-13
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, The unit comes standard with 6 feet (1.8 m) three wire cord, exiting from the rear of
the fireplace. Plan the installation to avoid the use of an extension cord. Preferably, the fireplace will be
on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the
fuse to blow when the heater is in operation.
OPERATING INSTRUCTIONS
This appliance can be operated by both remote control and manual button controls on the fireplace.
Once the unit has been properly connected to a grounded electrical outlet, turn on the main power
switch located on the left hand side of the appliance. A beep should be heard when the power is first
applied.
CAUTION! The unit’s power cord must be connected to a properly grounded and protected
120V outlet. Always use ground fault protection where required by the electrical code.
WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the
unit is damaged, please call a qualified service technician to inspect and to replace any part
of the electrical system if necessary.
NOTE! To use both remote and manual functions, the main power switch must be in “ON” position.
●
Operating by Manual Button
NOTE!
The manual button on the fireplace unit does not provide you with all function control, and it’s
purpose is to control some basic function in the event you lose the remote handset. Please use the
remote handset to carry out all functions.
Main power switch
Flame button
Heater button
Thermostat knob
5
4
3
2
1
9
6
7
8
NOTE
：
The lights will always be on when the appliance is on.
Main power switch
The POWER switch supplies power to all of the functions of the fireplace. This switch must be in the
“ON” position for any of the functions including the remote to work.
Flame button
By pressing the FLAME button, the unit will cycle through five flame effects. If you need more flame,
please use the remote handset.
Heater button
Press
to turn on low heat setting. (Pilot lights illuminated
●○
).
Press again for high heat setting. ( Pilot lights illuminated
●●
)
Press a third time to turn heat off completely. ( Pilot lights illuminated
○○
).
There are 3 levels you can cycle through including the OFF setting.
