21
❏
8. Position the remote needle valve mount where
desired so that the mounting screws will thread into the
side of the fi rewall (also making sure they will not interfere
with the engine mount screws already in place). Drill 3/32"
[2.4mm] holes for one of the screws and temporarily
mount the needle valve with two #4 x 1/2" [13mm] screws.
❏
9. Remove the screws, harden the holes with thin CA,
allow to harden, then mount the needle valve.
❏
10. Glue the laser-cut 1/8" [3.2mm] plywood
doubler
to
the bottom of the laser-cut 1/8" [3.2mm] plywood fuel-cut
servo mount
. Test-fi t your throttle servo and make any
necessary adjustments.
❏
11. Glue the fuel-cut servo mount and the laser-cut 1/8"
[3.2mm] plywood
support
for the front of the mount into
the fuselage.
Refer to these images to hook up the fuel-cut wire as
described in the following steps.
