26
Apply the Decals
1. The decals are die-cut from the factory.
2. Be certain the model is clean and free from oily fi ngerprints
and dust. Prepare a dishpan or small bucket with a mixture
of liquid dish soap and warm water – about 1/2 teaspoon of
soap per gallon of water. Submerse one of the decals in the
solution and peel off the paper backing.
Note:
Even though
the decals have a”sticky-back” and are not the water transfer
type, submersing them in soap and water allows accurate
positioning and reduces air bubbles underneath.
3. Position the decal on the model where desired. Holding the
decal down, use a paper towel to wipe most of the water away.
4. Use a piece of soft balsa or something similar to squeegee
the remaining water from under the decal. Apply the rest of
the decals using the same method.
GET THE MODEL READY TO FLY
Check the Control Throws
❏
1. Switch on the transmitter and receiver.
❏
2. Center the control surfaces.
FULL
THROTTLE
RUDDER MOVES
RIGHT
ELEVATOR
MOVES DOWN
RIGHT AILERON
MOVES UP
LEFT AILERON
MOVES DOWN
(STANDARD MODE 2)
4-CHANNEL RADIO SETUP
❏
3. Make certain that the control surfaces and the
carburetor/motor respond in the correct direction as shown
in the diagram. If any of the controls respond in the wrong
direction, use the servo reversing in the transmitter to reverse
the servos connected to those controls. Be certain the control
surfaces have remained centered. Adjust if necessary.
