GREAT PLAINS PL5500 PTO, Руководство по установке и обслуживанию

Страница: 19 / 28

PL5500 PTO Pump Kit Table of Contents
Great Plains | 411-774M | 2019 - 09 - 12 Table of Contents 17
Secure PTO Pump
Entanglement and Flailing Equipment Hazards:
Do not use a driveline, shaft extension, adaptor, or external
gearbox with the PTO pump. Extra fittings create
entanglement hazards. Fittings also destabilize the shaft, and
may make it impossible to adequately secure the pump against
torque and shaft slip. Never alter or remove any existing
guards on the tractor or PL5500 planter at any point of PTO
pump assembly kit installation. Contact your Great Plains
dealer for service.
5. With the torque arm firmly against the drawbar:
loop the chain once (4) around the drawbar,
then through the anchor point (5),
then around the drawbar (4) at least once more,
then through the keyhole slot (7) in the torque plate.
The drawbar loops prevent pump rotation.
The anchor loop retains the pump on the PTO shaft.
6. At least one full chain link must be exposed at the
slot (7) on the decal side of the torque arm plate.

If there are more than a few chain loops left at the
plate keyhole, route any excess chain through the
anchor point and/or around the drawbar.

Do NOT use any pins, cross - bolts, or wires to secure
the pump to the PTO shaft. Such fasteners are not
required for safe pump operation, and would add a
needless entanglement hazard.
7. Pull and twist the pump assembly to verify that the
chain is sufficiently taut to prevent excess pump
rotation or sliding along the PTO shaft.Prepare Fan
Disconnect Existing Fan Hoses
The PL5500 planters have two existing hydraulic hoses
(861-544C) from the fan assembly; they run from the fan
to the hitch. These two hydraulic hoses will continued to
be used with the PTO pump assembly kit. Additionally,
hydraulic hose (841-196C) remains part of the existing
fan assembly.
1. Set out a collection bucket near the ends of the
hydraulic hoses (861-544C) closest to the hitch.
2. Remove any hose handle housings (a).
3. Disconnect the hoses from the hitch fittings at the
JIC connections (b). Set aside the fittings (804-
022C) as these will not be used for the PTO pump assembly kit. Do not remove any of the connections to adapters
on the fan assembly, only at the hitch.
4. Set the open hose ends in the bucket to catch any fluids.
34622
5
4
7
6
34627
7
34676
b
a