GREAT PLAINS 3S-3000 Series, Оригинальное руководство пользователя

Страница: 34 / 50

4/25/19 Table of Contents 195-144M
3S-3000 Table of Contents Setup 30
Wing Box Alignment
1. Place a block ahead of the wing gauge wheels.
Refer to Figure 36
2. Pull forward against blocks to rock wing frames
back. Pull forward until stop bolts (3) are firmly
against toolbars.
Refer to Figure 37
3. Check for proper alignment by running a string line
(4) across back of drill toward outer ends of wings.
Make sure string is parallel to center box (both
measurements (5) equal).
4. For proper alignment, outside ends of boxes (6)
should be about 1 to 1
1 
4
inch (2.5 to 3.2cm) ahead
of inside ends (7).
5. To adjust box alignment, shorten or lengthen stop
bolts (3) to change the contact point with the
toolbars. Loosen jam nut and thread stop bolt in or
out. Adjust stop bolts in or out until outside ends of
boxes are 1 to 1
1 
4
inch (2.5 to 3.2cm) ahead of
inside ends.
6. Tighten jam nut.
Figure 36
Stop Bolt Location
18988
3
Figure 37
Wing Box Alignment Measurement
15654
6
4
7
5 5
7 6
4