CMR-45U CABLE MANAGEMENT RACK
TOOLS
9/16" socket or wrench
ASSEMBLY
1.
Install front cross-brace and front horizontal width bracket
A.
Lay Upright Channels on edge and open sides of the channel to
face each other.
B.
Locate thru holes at the top of the channel; align Cross Brace
Waterfall Edge behind the top holes (for 19" mounting, use outer
set of holes; for 23" mounting, use inner set of holes). Install (2)
3/8" Hex Head Bolts, (4) 3/8" External Tooth Lock Washers, and
(2) 3/8" Hex Nuts on each channel,
FINGER TIGHTEN.
C.
Locate thru holes at the bottom of the channel; align Horizontal
Width Bracket in front of the bottom holes. Install (2) 3/8" Hex
Head Bolts, (4) 3/8" External Tooth Lock Washers, and (2) 3/8"
Hex Nuts on each channel,
FINGER TIGHTEN.
2.
Install rear horizontal width bracket and rear cross-brace
A.
Locate thru holes at the bottom of the channel; align
Horizontal Width Bracket in front of the bottom holes. Install (2)
3/8" Hex Head Bolts, (4) 3/8" External Tooth Lock Washers, and
(2) 3/8" Hex Nuts on each channel,
FINGER TIGHTEN.
B.
Locate horizontal slots on the front Cross Brace. Install Center
Waterfall Bracket to the Cross Brace with (1) #12-24 Screw. Install
second Center Waterfall Bracket in the same way.
C.
Locate thru holes at the top of the channel; align Cross Brace
behind the top thru holes. Install (2) 3/8" Hex Head Bolts, (4) 3/8"
External Tooth Lock Washers, and (2) 3/8" Hex Nuts on each
channel,
FINGER TIGHTEN.
D.
Return to the Center Waterfall Brackets. Fully attach each
bracket by using (1) #12-24 Screw through the rear cross brace.
3.
Final tightening
A.
Stand rack upright. Screws will self square the rack, verify with
square. Tighten all screws using a 9/16" socket or wrench (24 ft-lb
torque is recommended).
4.
Installing cable rings
A.
Align the pins on the rear of the cable rings in any of the 16
mounting locations per upright channel and use one #12-24 Pan
Head Screw.
5.
When mounting to a cement floor, recommended mounting
hardware is Great Lakes Seismic Anchor Kit (AK101). For other
floor construction, the installer must provide appropriate hardware.
14
