IS400 machine
. 14
First contact
Installing
Before carrying out the following operations, make sure the machine is switched off
and unplugged, switch
(I)
to position 0.
Physical installation advice
• Put the Gravograph machine onto a stable flat, clean surface
with mini. sizes of 520x500 mm
.
Make sure the back of the machine is well-ventilated, do not put it too close to anything (wall, other machines etc).
• Clear the work surface so that you can
- easily and quickly access all external parts of the machine,
- quickly access, in case of necessity, the stop switch ON/OFF
(I)
at the right side of the machine,
- make sure that all moving parts of the machine have enough room to move freely,
- avoid any accidental unplugging of the cables.
The machine's power supply cable being used as a sectionning device, it must be easily
accessible and the wall plug must be installed near the machine and must also be easily
accessible.
The connectors screws must be very tight to avoid accidental disconnection of the
cables while the machine is turned on as this could permanently damage the electronic
cards (label
).
• Protect Gravograph equipment against:
- Moisture (rain, snow, condensation…),
- Heat (direct sunlight, heating…),
- Brusque temperature changes,
- Dust (exhaust pipe),
- Liquid splashes, spillages on the electronic rack, cables and connections, and any other part of the machine;
unless recommended by GRAVOGRAPH (ex. : lubrication)
- Vibrations,
- Electric or electronic radiation.
