Gravely Ariens 815134, Руководство владельца/оператора

Страница: 13 / 26

13
6. Mount front of support bar to the mower frame
using 3/8 x 3/4" clevis pin, 3/8" washer and bow-tie
locking cotter pin. (The bar must be on the inside of
the frame, as shown in Figure
14.) Tighten
hardware installed in step 5. See Figure 14.
INSTALL BAG ON FRAME
1. Thread the bag frames (item 23) through the sleeve
on the open end of the mesh bag (item 2). See
Figure 15.
2. Install the 3/8 x 1/2 x 3" plastic tubes (item 24) on
the ends of the bag frames and push then ends
together. on the ends of the bag frame and push
the ends together. See Figure
15.
NOTE: The rope handle on the bottom of the bag will
point to the outside when the bag is assembled correctly.
CAUTION: MAKE SURE the heat resistant
(smooth side) side of the mesh bags is facing
the unit.
Figure 14
Clevis
Pin
3/8" Washer & Bow-Tie Locking
Cotter Pin (Not Shown)
Figure 15
Thread bag frame (item 23) through sleeve in mesh
bag (item 2).
Install 3/8 x 1/2 x 3" plastic tube (item 24) on each end
of frame and push the ends together.