Gravely Ariens 815134, Руководство владельца/оператора

Страница: 10 / 26

10
2. Use the red footrest (item 25) that is included in the
kit, and lay the footrest onto the back of the weight
tray (similar profile). It may be helpful to have the
weight tray laying upside down on the ground when
mating it to the footrest. Install two 1/2 x 2" bolts
(item
9) thru the front of the weight tray and
footrest. Slide the two spacers (from step 1) over
the bolts and secure with push nuts (item
11).
Secure the push nuts as tight as possible. See
Figure
4.
3. Place the footrest/weight tray assembly over the
chassis. The two 1/2 x 2" bolts (item 9) will drop
through the two holes in the chassis. It may be
necessary to tilt the assembly back slightly to align
the bolts with the holes. Secure with two 1/2" nyloc
flange nuts (item
10). See Figure 5.
4. Install two 5/16 x 1" bolts (item 5) through the two
holes on the footrest portion of the assembly.
Secure with two 5/16 nyloc flange nuts. Adhere the
grip adhesive (item
3) just above the two bolts
(item 5) on the footrest. See Figure 4.
5. Place the cast iron weight (item 4) into the weight
tray. Install two 3/8 x 3" hex bolts (item 7) and two
3/8" lock washers (item 8) through the front of the
weight. There are two weld nuts on the back of the
weight tray. Thread the bolts into the weld nuts and
tighten until the lock washers engage. Do not
overtighten the bolts or the tray will flex. The bolts
are only installed to prevent the weights from falling
out of the tray. See Figure
6.
INSTALLING BAGGER BOOT
MODEL 815134
See Figure 7.
1. Slide boot bracket under discharge chute bracket.
NOTE: Discharge chute can remain attached to deck.
2. Using front and rear boot straps, secure the boot by
attaching boot straps to deck posts.
INSTALL BAGGER BOOT
MODEL 815142
See Figure 8.
1. Lift discharge chute and insert discharge bagger
boot into deck discharge opening.
NOTE: Discharge chute can remain attached to deck.
2. Insert bagger boot fully into opening making sure
that the front of the boot is positioned inside of the
deck shell and the top edge of the boot is
positioned on top of the deck shell and below the
discharge chute.
3. Push the bagger boot fully into the discharge
opening and attach the rear boot strap to the rear
attaching post.
4. Attach the boot front strap to the front attaching
post.
WARNING: On multi-blade mowers, rotation of
one mower blade will cause all blades to rotate.
WARNING: Mower blades are sharp and can
cut you. Wrap the blades or wear gloves, and
use extra caution when servicing them.
Figure 7
Front
Deck
Post
Front Boot Strap
Boot Bracket
Slide boot
bracket under
discharge
chute.
Secure boot by
hooking boot
straps to front and
rear deck posts.
Boot