GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. Technical modifications reserved!
03/2011
5
Assembly instructions
Carefully unpack the model, the masts and all the
small items.
NOTE:
don’t forget the four davits: they
are packed in white protective film, and are easily
overlooked.
Assemble the boatstand and glue the joints.
Uses the tip of a knife to lever up the central leaf-
spring in the receiver connector attached to the
sailwinch, then cautiously withdraw the red wire and
its contact from the connector housing. Bend the wire
double and wrap adhesive tape round the bare
contact to insulate it.
NOTE:
this measure is
necessary because both the sailwinch and the speed
controller feature a BEC system, and only one of
them may be used. If you are installing the
recommended RC components, the NAVY V40R
features the more powerful BEC system, so this one
should be used.
Unscrew the sheet guide flange, and install the
sailwinch in the appropriate position. Unscrew the
bezel from the sailwinch switch, fit the switch through
the opening from the underside, and screw the bezel
on the switch again.
NOTE:
check that the bezel is
the right way round (switch ON / OFF position). Press
the switch into the opening.
