GRAUPNER/SJ GmbH D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
04/2013
3
The picture shows the right-hand wing panel already in its final position. The servo
lead should be guided forward as shown while the left-hand wing panel is fitted.
Please note that it takes considerable force to push the wing panels together fully.
Tip:
it is easier to engage the wing panels if you slightly compress the two raised lugs
of the left-hand wing panel just before pushing the panels together. The wings will
slide together more easily once you have assembled the model a few times.
Configuring the MX-10 transmitter (not included; supplied in Order No. 33110)
Your transmitter should be configured as described and illustrated before you use it
to control the
V-VENTURE
: first set the right-
hand stick to ‘non-centring’ action to
control motor speed; see the MX-10 manual for details of the procedure.
The picture shows the configured transmitter: the
right-hand
stick is pulled back to
the “motor off” position, and the
jumper switch
is
fitted in the ‘far left’ position, so
that servos 2 and 5 are mixed for the aileron function.
Please note that the “speed brake” function is only possible with a programmed GR-
12 receiver (see download on our website for Order No. 9910.100, and the notes in
the “Speed brake” section in these operating instructions. In this case the jumper
switch for servos 2 and 5 should be left in the standard centre position).
Connecting the GR-12 HoTT receiver (not included; supplied in Order No.
33110)
