GRAUPNER/SJ GmbH D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. Technical changes reserved!
03/2012
6
Dive functions
The dive function controls the filling of the ballast tank. When water floods into the tank, the model becomes
heavier and will submerge. Surfacing is achieved by reducing the amount of water in the ballast tank. It is easy
to achieve a buoyancy level for the model in the water by briefly tapping on the dive or surface pushbuttons. If
the model will not submerge despite a full ballast tank, there must still be small air bubbles inside the open area
on the tower or clinging to the hull. Press the model briefly under the water surface by hand and gently shake it
a little until the bubbles rise.
Maiden voyage
Charge the battery and test the model's functions. Check if all plug-on parts are securely seated, particularly the
switch hatch. Now the maiden voyage can begin. It may be necessary to briefly press the model under water to
release air bubbles from the tower's open area. Take it easy during the maiden voyage. Take the time to
become familiar with the model's maneuvering behavior. Do not maneuver far away, the model must never go
out of sight.
Now have a lot of fun with your U-16 Emden model submarine.
Potential problems and their remedies
Remote control unit has no range
Transmitter batteries almost fully discharged,
replace batteries
Battery in the model almost fully discharged,
recharge
Antenna not extended, pull out the antenna
LEDs on the transmitter do not light up despite new
batteries
Batteries installed wrong, insert batteries with
correct polarity orientation
The green LED on the transmitter does not light up
Batteries in the transmitter are discharged, replace
batteries
The model operates slower than usual, will not run
straight ahead correctly or is difficult to control
Battery in the model almost fully discharged,
recharge right away
The screws (propellers) have become fouled, clean
the propellers right away
The charger no longer charges the model's battery
properly, green power-on LED no longer lights up
Batteries in the charger are discharged, replace
batteries
Model will not dive properly
Briefly press the model under water to release any
air bubbles that may be present in the tower's open
area
Ballast tank cannot be controlled, driving motors still
function, green LED in the tower is off
Battery in the model almost fully discharged,
recharge battery
Also necessary (but not in the kit)
2 sets of 4 each, mignon P4 high-performance dry-cell batteries, (6 batteries needed)
order no. 3426
This model may be operated in all EU countries!
switch hatch
The model will dive or
surface at a rate which
depends on the amount
of water in the ballast
tank.
