GRAUPNER/SJ GmbH D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. Technical changes reserved!
03/2012
3
IMPORTANT
: The rechargeable battery built into the model must not be disposed of in household waste.
The rechargeable battery must be turned in at an appropriate collection point. The model must be opened to
do this.
IMPORTANT
: The model and the transmitter may not be thrown away as household waste but must be
turned in to a collection point for electrical waste materials. Ask your local authorities about this.
Never expose the model, the charger or the transmitter to severe heat, cold or contamination.
Protect the model, charger and transmitter against damage or slipping while they are being transported.
Never
operate the model in moving water (e.g. a river) because, as a consequence of its slow speed and
the poor visibility in murky water, the model could be carried away by the current.
Never endanger
yourself
or
others
in an attempt to
recover
the model.
Pay particular attention to the model's water-tightness. A model submarine will sink if it takes on too much
water. Prior to every use, check the model for any damage and ensure the model is watertight. The switch
hatch
must always
be closed down watertight onto the hull when the model is operated!
Allow the model dry out good after it is used.
Care and maintenance
Clean the model after every use. Rinse off the watertight-closed model with clean tap water. Remove any
water which may have intruded. If water has gotten into RC components, allow the model to dry out then
send it to the responsible GRAUPNER/SJ service center for inspection.
Clean the model, charger and transmitter only with suitable cleaning materials. A lint-free cloth is suitable.
Never
use chemical cleaning agents, solvents, gasoline, spirits or similar.
After operating the model, lubricate drives with a small drop of oil because the bearings also serve as the
shaft's seal against water intrusion. To lubricate the drives, use only oil which does not contaminate or
pollute water (e.g. order no. 206).
Operating
instructions
With the transmitter switched off, insert the batteries into the transmitter. To do this, remove the Phillips-
head screws on the bottom of the transmitter and lift off the cover. Insert the mignon batteries (AA) with
correct polarity (see marks in the battery compartment) then screw on the cover again securely.
