P4
Normal Mode
(1) Basic Operation
- When Power on, the last used memory will be bound to
Receiver.
- In case of No Receiver connection, if you press the
button of left stick for 1sec, it will search Receiver.
- if Receiver is not searched, it will be repeated until find
Receiver, and you can bind with new Receiver by
pressing BIND/LED Switch.
(2) BIND mode
In case of no having receiver, which is already saved in
memory, then you can bind with new receiver by
pressing BIND Switch.
If Receive Signal is normal, RED LED will be turned On.
In case of Waiting Receiver or Range warning, RED
LED will be slow blinked.
(3) Range Test mode
Functional switch: Press shortly button of SPEED +
SNAP once.
After Binding with Receiver, if you shortly press this
functional Switch, Range Test mode will operate for
90sec.
While operating Range mode, if you shortly press this
switch, Range test mode will be ended.
At Range mode operation, RED LED will blink quickly
and make buzzer sound.
After 90sec, Beep sound will be occurred one time, and
enter to Main Mode.
(4) Low Battery Voltage warning
RED LED will do fast blinking. ( RED LED indicate State)
At under 3200V, Warning will be announced and at
3300V, warning will be removed.
3Cell Alkaline Battery will be used.
Important Point :
While Binding, Transmitter should always have distance
from the Receiver. At least 1m should have.
Otherwise, it might be connected to Return channel, and
do malfunction.
Program Mode
(workable only at Binding condition)
(1) Condition of Basic Operation
Enter to Program mode : Press two Stick Switch
simultaneously for 2sec.
Release Program mode : Press two Stick Switch
simultaneously for a second.
Indication of Program mode : Red Led will be blinked
once per a second interval
.
Program mode : Blink once per a second interval
(2) Saving Data
50pcs of last used Data could be saved.
(3) Adjustment of Servo End Position
In case of Stick Calibration, Default will be 100%. At this
value, Customer can adjust trim as below way.
- 100% --> 1100us ~ 1900us
At Max. or Min. Position of Stick, adjust Trim Switch
Range of Trim is available 0% ~ 100% ~ 150%.
If move to 100% position, High Beep sound will be
occurred once.
- Red Led will be blinked once per a second interval
Program mode : Blink once per a second interval
(4) Servo Reverse Set
This is used when change Servo direction.
All sticks are on neutral position, and move the trim
switch to Max. or Min. Position.
If press Power switch with pressed trim switch to Max. or
Min. position, Normal mode and Reverse mode will be
changed.
- Indication of Servo Receiver mode : Red Led will be
blinked once per a second interval
- Normal mode : Green LED will be blinked once per a
second interval.
