GRAUPNER Alpha 150Q, Руководство пользователя

Страница: 17 / 48

17 / 48
16571.GPS_Alpha150Q_V2.0sh.en
• A suitable mobile phone with Android operating system.
• The app "GraupnerSJHoTTViewer2" on the mobile phone.
For transfer to the Kopter you will need:
• "micro USB OTG to micro USB cable", No. 33002.OTG0M5
• Update adapter, No. S8500
• Update cable, No. 7168.S
Notes
• When the GPS is connected, the copter only allows the motors
to be switched on if 6 GPS satellites or more are found.
• While searching for GPS satellites, an HD camera should be off.
If more than 8 satellites have been found, the HD camera can be
switched on again. Then check the copter's telemetry display to
see if there are more than 6 satellites left.
• The Autopilot and Come back home mode only work in the con-
figuration of how the compass was calibrated (eg with HD cam-
era on). If the airfield is changed, the compass must also be re-
calibrated for safety's sake.
• If the departure of the pre-programmed waypoints is inter-
rupted and switched to "autopilot" mode, the copter will stop
at the point of interruption.
Carefree Autopilot mode
As soon as the left front switch S4 is brought into the upper position,
the right front switch S6 is in the middle position and the upper right
switch S3 is in the rear switch position, the copter is in the carefree
control mode.
From the point of view of the pilot standing on the ground in this
control mode, the left / right orientation of the directional control is
maintained even if the copter was rotated 180 degrees by the "yaw"
command and thus falls on the pilot. This facilitates the control of
the copter in difficult visibility conditions, as this eliminates the oth-
erwise necessary "side-reversed" control.
In the servo display this looks like the one on the left: The bar of C5
ends at -100%, the bar of C6 in the middle, at 0%, and the bar of C7
on the right, at +100%.
As soon as S3 is brought back into the front switch position and thus
the bar of C7 left of +50%, the copter is back in the normal control
mode. How far left of +50% is insignificant, see picture left.
10mAh I 0A
0:00 Dir: 0°
11.6V Alt: 0m
0km/h 0°
6 0m
C+00016 +00060 -00011
1
3
5
7
+
0%
9
11
–100%
0%
2
4
6
8
+
0%
0%
0%
0%
10
12
0%
0%
0%
0%
–100%
1
3
5
7
+
0%
9
11
–100%
0%
2
4
6
8
+
0%
0%
0%
0%
10
12
0%
0%
0%
0%
+100%
I5
I6
I7
+
trv
+100% +100%
+100%
+100% +100%
I8 +100% +100% free
SW6/7
3
SW4/5
+100%
I9
+100% +100%
free