16
Setting Up Your Kaleido-MX Multiviewer
Networking Setup
16 Once the startup has completed, check the card’s Status LED again, and make sure that
it does not indicate an error condition.
Should the Status LED indicate an error condition, refer to your Kaleido-MX (1RU)
Hardware Description & Installation Manual to find out what the other LEDs might be
indicating.
17 Verify that the new IP address is effective, by referring to
Verifying an Output Card’s IP
Address and Application Version
, on page 35.
Configuring the Network Settings for a Quad-Head Kaleido-MX
To configure the network settings for a Kaleido-MX with two output cards
1 Press the Select button on the front edge of one of your system’s
output
cards.
The Status LED on the selected card flashes orange, and the associated control menu
appears on the display of the Densité frame’s local control panel.
2 On the local control panel, press the [–] button repeatedly until NETWORK SETTINGS
appears on the display, and then press the SEL button.
Green
Normal
Blinking orange Booting (or the card is selected for local control)
Red
Firmware initialization in progress / no Ethernet / SD card error
Blinking red
Fan failure / no rear / duplicate IP address
Select button
Status LED
