23
Kaleido-MX (1RU)
Quick Start Guide
series of Audio Bridge Terminal panels through SDTI inputs. The ABT-64 supports
64 channels and the ABT-128 supports 128 channels.
There is not enough space on the Kaleido-MX rear panels to also include discrete audio
connectors. An ABT provides connector space for multiple audio signal inputs, and
multiplexes all the audio signals into combined serial feeds on coaxial cables that connect
to Kaleido-MX input cards.
To configure the IP address and other network settings of the ABT
1 Connect a PC to a switch.
2 Referring to
Configuring a Client PC
, on page 24, configure the PC with the following
network settings:
3 Apply power to the Audio Bridge Terminal and make sure it is connected to the same
switch as the PC.
• If the switch is Power over Ethernet (PoE) enabled, simply connect it to the unit
using an Ethernet cable.
• If not, PoE mid-span (
inserter
) equipment must be placed between the switch and
the Audio Bridge Terminal.
4 Press the RESET button (located on the right-hand side of the ABT rear panel beside the
ETHERNET/POWER RJ-45 connector) for at least 1 second.
The Audio Bridge Terminal will reboot with the following static network configuration:
Note:
The ABT is powered through the RJ-45 Ethernet connector. There is
no power ON/OFF button, so the device is ON whenever a powered Ethernet
cable (PoE) is connected.
DHCP
OFF
Static IP address
10.0.0.1
Subnet mask
255.255.0.0
Default gateway
10.0.0.1
DHCP
OFF
Static IP address
10.0.3.190
