50
CameraMan 3-CCD Presenter Camera System Installation and Operations Manual
Appendix B
•
If the battery is fully charged and the
TRACKING UNIT STATUS LED is still
OFF, check that the
RF CHANNEL switch
on the back of the Main Docking Station
matches the position of the RF Channel
switch on the back of the Tracking Ring
Power Pack.
3.
Is the autoTRACK LED on the camera’s display
panel illuminated or flashing?
•
If it is ON, proceed to step #4.
•
If it is OFF, use the Tracking System
Keypad to select one of the four
autoTRACK View buttons.
4.
If the POWER and the TRACKING UNIT STA-
TUS LEDs are illuminated, and the autoTRACK
LED is blinking:
•
Check to make sure that the
Tracking
Ring Sensors
are attached properly and
are not covered by hair or clothing.
•
Be sure that you are standing in the field-
of-view of the camera.
Problem
The CameraMan Camera’s autoTRACK opera-
tion is irregular.
Solution
1.
Check the
Battery LOW LED
on the top of the
Tracking Ring Power Pack. If the LED is illumi-
nated, the battery is low and needs to be
recharged.
2.
If the battery is charged, you may need to
change the RF frequency on which the Camera-
Man is currently operating. To do this, change
the position of the
RF CHANNEL switch
on the
back of the Main Docking Station and RF CHAN-
NEL switch on the back of the Tracking Ring
Power Pack to the opposite setting (both switch
positions must match).
3.
Inspect the CameraMan Camera’s location to
verify that no
obstructions
, such as the main
