GRAPHTEC MP303-04, Руководство пользователя

Страница: 31 / 73

2-7
2.5 Setting the Pen Speed Mode
The pen speed mode can be set to Manual or Program mode.
Program mode: Command input specifying the pen speed will override the pen speed setting that was manually
selected at the plotter's control panel.
Manual mode : The pen speed setting that was manually selected at the control panel remains effective and
command input specifying the pen speed will be ignored.
■
Procedure
(1) Press the
M O D E
key and then press the or key to display the message below.
Setup
DipSW.
(2) Press the
E N T E R
key to display the command selection menu (the currently selected command mode is
displayed).
（ c o m m a n d m o d e ）
(3) Press the or key until the “Speed” menu is displayed. In this example, the pen speed mode is
currently set to M (Manual).
Speed M
(4) Press the or key to switch the pen speed mode between M and P (the bit which affects the pen
speed mode setting blinks).
Speed M : Selects “Manual” pen speed mode.
Speed P : Selects “Program” pen speed mode.
Speed P
(5) When the desired status is displayed, press the
E N T E R
key. The prompt below appears.
Reset?
ENTorCAN
(6) If the setting is correct, press the
E N T E R
key. Pressing the key resets the plotter to allow your new setting
to take effect.
To cancel the setting and return to Step (1) , press the
C A N C E L
key.
Ready Ready
or
X=
Y=