GRAPHTEC FCX4000 SERIES, Руководство по установке

Страница: 5 / 16

5
3
Make sure that the tool bracket is engaged on the tool's flange, and then tighten the screw.
Flange
Bracket to hold tool
Tool holder screw
Removing the tool
When removing the tool, turn the tool holder screw counterclockwise to remove the tool.
2 Loading the Media
Supplement
• This plotter is available with a electrostatic writing panel.
• There are media that cannot be held down by any method. Please test before use.
• Antistatic-treated media cannot be held down in electrostatic writing panel.
• If air gets in between the writing panel and the media during loading, force out the air and ensure that the media is
securely attached to the writing panel before cutting.
• When cutting a media that doesn’t come with a backing sheet on the electrostatic writing panel, spread a vinyl backing
sheet or something similar on the panel before cutting. Replacement of damaged writing panel is available for a fee.
• When loading a media that cannot be securely attached on the electrostatic writing panel, reinforce adhesion by using
tape on all four sides.
• When using the electrostatic writing panel, do not use a spray glue and a spray glue remover directly on the writing
panel.
• When the media is changed to a different type, we recommend that you perform the registration mark sensor
sensitivity adjustment. (See “Adjusting the Sensor Level” in the User's Manual (PDF).)
How to Load the media
(1) Make sure that the [CHART HOLD] key is turned off.
(2) Place the media on the writing panel.
(3) Press the [CHART HOLD] key (to hold-down the media) next to the control panel.
(4) The green [CHART HOLD] key lamp (to hold-down the media) lights to indicate that the media is being held by electrostatic
adhesion.
Supplement
Press the [CHART HOLD] key (to hold-down the media) again to release the electrostatic adhesion. The green lamp will not be lit.
It may take some time to be able to hold-down the media by pressing the [CHART HOLD] key (to hold-down the media) depending
on operating environment.
After the media has been held for a while by electrostatic adhesion, it may become charged with static electricity and therefore be
harder to remove from the writing panel. There is nothing abnormal about this phenomenon.