23
Use a 2mm Allen key to loosen the set screw in the exit wheels. This will allow
you to move the wheel along the shaft. On the exit wheel you will see four threaded
holes. Take two of the M3*10 screws and install one lower knife on to it, tighten it
with 2.5mm Allen key. Install the other side of the lower knife in the same method;
the two knives should match up as shown below.
Once the lower knife is installed, loosen the rubber exit wheel with a 2mm Allen
key. Use M3*6 Allen screws to install the perf blade on the rubber exit wheel, tighten
the screws with 2.5mm Allen key. In the same fashion as explained above, install
the other perf blade.
Adjust the location of the metal exit wheel and the rubber exit wheel to where the
perf blade and lower knife are up against each other.
