Continuous Vinyl Printing Instructions
To set the cutter, select the
Stock
tab. Set the Media Settings “Type” to
Continuous
. In order for the automatic
cutter to cut after each label, under
Media Handling “Post-Print Action,”
select
Cut
, and next to “Occurrence”
select
After Every Page
(these
settings may be adjusted later to your
speci
fi
cations in the Printer Properties
as you are printing your labels). Select
OK
on the bottom of the Printing
Preferences window.
Die Cut Label Instructions
Die-Cut Label Calibration
In order to print die-cut labels, the label
stock needs to be calibrated. To do so,
with the printer power OFF, hold the
FEED/STATUS button down while turning
ON the printer. The feed/status button
will blink green twice, switch to solid
red, then begin to blink red. Release the
feed/status button when it begins to
blink red. Supply will feed out while the
printer calibrates to the die-cut gap.
Driver Settings for Die-Cut Labels
For die-cut labels with the 1/8" gap, the settings on the
Stock
tab should be as
follows: “Print Method” should be set to
Thermal Transfer
, the “Media Type” should
be set to
Labels With Gaps
.
NOTE:
It is possible that the position of the supply causes two labels to feed out; however, the third
label will be aligned correctly and ready to print.
-19-
Содержание DuraLabel 4000
Страница 6: ... 4 ...
