78mm
1
2
8
m
m
38mm
1
1
8
m
m
3
10
Installation
12.Before contacting the power cable of projector lift, please take out the wire cover in the back of lift (
Figure 18). Then choose the control option and connect the controlling wires to terminals( Figure 19-
20). For humanization, link the power after fixing the controller of cables on a place for easy using.
Notes: Ensure the supply voltage is matching the normal working voltage of this product, and the
recommended power is 2 times more than the sum of lift's power and projector's power.
It will be dangerous and will lead to damage of product in case using mismatching power supply.
Caution: The electrical work should only be installed by a qualified electrician or it may cause product
damage even personal casualty.
Figure18
13. Please adjust motorized lift to keep balance in need, if there is unbalanced changes occur in
controlling up and down several times after power on.
14. Adjust the height of decorative ceiling plate depended on the actual ceiling height, and twist
setscrew nut on the 200mm long screws assembled in the four corners of decorative ceiling plate.The
max height is about 200mm(Figure 22).
Please tightening screws to advoid looseness.
Please cut short the standard 200mm long screws or use a shorter screws once the distance of
decorative ceiling plate and multiorifice plate is too close.
Accessories
M4 Hxagonal Adjuster(1 pc)
M5、M4、M3x20mm Screw(each 4pcs)
Rubber Washer
(4pcs)
Φ
16
x
Φ
5
.
2
x
10mm
Ceiling punching positioning paperboard
Long ribbon (3 pcs)
6P-4 power wire clip (1 pc)
Product certificate (1 pc)
User’s manual (1 pc)
Optional accessories
Installation Bar(4pcs)
M10x500 Threaded Rod(4pcs)
External remote control kit (with RS 232/485 control function)
External IR remote control set(3rd generation), model: 1GD-IRAnIII
External RF remote control set(3rd generation), model: 1GD-868MnIII
M10 Nut、Washer(16pcs/each)
Hanger(4pcs)
In line switch ( 1 set)
Cables
RCA coaxial video cable
VGA extended cable
HDMI High definition extended cable
Alternating current extended cable
15.(Figure 24)Trim the ceiling plate to the appropriate size and assemble it back into the ceiling grid. The
suggested distance of ceiling plate to the lift's decorative ceiling plate is about 5mm. Please use the
same way to adjust the ceiling plate in case the height of decorative plate is not the same as the
ceiling plate around.
m
a
x
=
2
0
0
m
m
上升/UP
公共/COM
下降/DOWN
(相线/L)
(零线/N)
(相线/L)
外壳
接地
wire cover
Power Line In
Terminals
Figure18
Figure19
Figure20
Figure21
Adjusting Nut
Height adjusting
screw of
decorative board
Shorten the screw to fit
Figure22
Figure23
Figure24
