WARNING: Important safety instructions.
It is important for the safety of persons to follow these
instructions. Save these instructions.
It is important for the safety of persons to follow these instructions
- For models with fixed control, do not allow children to play with fixed controls.
Keep remote controls away from children;
- Frequently examine the installation for imbalance and signs of wear or damage to
cables and springs. Do not use if repair or adjustment is necessary;
- Do not stand below the product when it is working;
WARNING: Important safety instructions.
Follow all instructions, since incorrect installation can
lead to severe injury.
- Before installing the drive, remove any unnecessary cords and disable any
equipment not needed for powered operation;
- For models with wall switch fixed control, the actuating member of a biased-off
switch is to be located within direct sight of the driven part but away from moving
parts. It is to be installed at a minimum height of 1,5 m; - when projector lift
completely opened, the moving part at least 2.5 m above floor level or other
access level.
Trouble Shooting
The Grandview GPCK-ME is designed for many years of use. Problems are usually caused by small issues or
improper use. If there problems please refer to the follow trouble shooting list. If problems persist, please
contact the authorized dealer or call 020-84899499 for technical support
Limit three year warranty only
Grandview provided limit three year warranty on motorized projector lift products. Grandview's sole obligation under this
warranty shall be to repair or to replace the defective part of the merchandise if the projector lift has been operated properly.
This warranty does not apply to apparatus showing evidence of misuse, abuse or accidental damage, or which has been
installed or operated improperly.
The projector
lift can not
funtion
properly after
installation.
Causes
Power cable is no connected
Refering to the user manual and connect the power cable
Outlet does not have power
Verify the wall outlet if it has sufficient voltage to support
the operation.
Refering to manual guide and make sure the control
switches are well positioned (up, down, stop)
Control switches have not
been properly positioned
Solution
