7
4
1. Turn the manual/IR remote control switch to position "0" ( remote control stalls ) ( Figure 20 ).
2. Take out the External IR Receiver, and connect the end to the relevant access in the end cap ( Figure 21 ).
4. After installing the IR receiver, you can use the remote control emitter to control the screen ( Figure 23 ).
3. Tear off the glue at the back of the receiver and put it at anywhere where IR singal is available ( Figure 22 ). ( Note:
Make sure the glue surface is clean )
How to install the battery:
1.Turn the controller around, push to open the cover as guide arrow.
2.Put the battery in according the guide of cathode and anode.
3.Close the cover.
UP
DOWN
STOP
LED
remote controller
Controller button instruction
1.To raise screen press "UP .
2.To hold screen at desired position press STOP .
3.To lower screen press DOWN .
1.
2
will
3
will
if
4
5
6
7
"
"
"
"
"
Caution:
The shortest distance between receiver and controller is 0.5 meter.
.Controller
work within 30 degree away horizontally from t he cen ter of recei ver
point within 8 meters from the screen.
.The controller
not work the signal was coveredby something.
.Keep the controller far away from high temperature and humid situation.
.Please change the battery when the signal is weak.
.Please take the battery out if the controller was not being used for long time.
.Please choose the same type battery as original supplied.
4. To raise the screen little at your desired position press MICRO-UP
5. To lower the screen little at your desired position press MICRO-DOWN
1GD
IRan
MICRO-UP
MICRO-DOWN
Instructions
How to use IR Remote Control
Figure 20
Figure 21
Figure 22
Figure 23
