GRANDSTATE 11132311, Безопасность, установка, эксплуатация и техническое обслуживание, Страница: 17 / 41

17
Setting up the grill
After purchasing your gas cylinder you will then be ready to set it up with your gas grill.
a) When changing the gas cylinder which shall be carried out away from any source of ignition.
Position the gas cylinder in the cabinet gas cylinder holder.
b) When ready to use your gas grill insert the regulator into the gas cylinder valve and tighten firmly.
The recommended hose length is about 1.0 m. The hose must not be longer than 1.5 m.
Always check for leaks after every change of gas cylinder
Check all gas supply fittings for leaks before each use. It is handy to keep a spray bottle of soapy
water near the shut-off valve of the gas supply line. Spray all the fittings. Bubbles indicate leaks.
Warning
Since this barbecue has no restriction in the emission of unburned gas, this barbecue must be installed
and/or used outdoors or in an amply ventilated area.
Strongly recommends minimum clearances from combustible materials must be:
Rear – 450mm
Sides – 250 mm
Top – 1000 mm
Strong wind is not allowed
to blow through the back
openings of the gas grill.
Energy saving tips
a) Reduce the opening time of the lid.
b) Turn the grill off as soon as cooking is completed.
c) Preheat the gas grill for 10 to 15 minutes only. (Except for the first use)
d) Do not preheat longer than recommended.
e) Do not use a higher setting than required.
> 450 mm
> 1000 mm
> 250 mm
> 250 mm
TBS MANUAL GS FALCON 311 DIN A4 RZ.qxp 13.08.20 10:09 Seite 17