CHAPTER 3
8. If your TV does not have a VIDEO input, you may connect through a VCR's
VIDEO IN. Note: Since virtually every VCR is different, please refer to your VCR
User's Manual for exact instructions for recording an external video source.
TECHNICAL TIPS
The following are problems that might arise when using the PC to TV converter, and
possible solutions to them.
To connect the Grand Ultimate Wireless to a VCR for recording, follow these steps:
1. Using either the RCA or the S-video (recommended) cable, connect from the
video out on the Grand Ultimate Wireless to the Video IN on the VCR
2. Using either an RCA or a 75 Ohm coaxial cable connect from the Video OUT on
the VCR to the Video IN on the TV
3. Set the TV/VCR switch on the VCR to "VCR"
4. Set the TV to display the video input signal (Refer to TV's User's manual for
instruction on displaying an external video source)
Q: How can I enhance the display quality?
A:
You can usually decrease the contrast and increase brightness control to get
the better picture.
Q: I connect with a NOTEBOOK PC, no output is displayed on TV.
A:
Please refer to your computer’s User’s Manual to display an external VGA Signal.
(Many Notebook computers have 3 settings, VGA external only, VGA internal only,
and VGA internal & external simultaneously)
5. You should be able to see the converted computer display on the TV
6. Insert a blank tape into the VCR and press "RECORD". Stop the tape after a few
moments to test that it is recording.
11
12
