2.5 STEP BY STEP CONNECTIONS
NOTE: Connecting anything other than a 6V DC power supply with a center
positive connector to the Grand Ultimate Wireless will cause damage to the
product and
will void the warranty
. GrandTec recommends using only the
supplied power supplies when using the Grand Ultimate Wireless.
IMPORTANT! Turn your computer OFF before connecting
the Grand Ultimate Wireless!
1. Connect the end of the H Cable that is RED to the port on the Ultimate Wireless
labeled SCAN CNVTR (which is also red).
5
.
Connect the Grand Ultimate Wireless Receiver to your TV using the AV Cable.
Plug the power supply to the DC IN of the Receiver and then connect the supply
to a wall outlet.
2. Connect the end of the H cable that is BLUE to the CRT port on the back of your
laptop or desktop PC. On a desktop, you may need to first unplug the monitor.
Fig. 3 – Laptop Connection Fig. 4 – Desktop with Monitor
3. Connect one end of the audio pass-through cable to the AUDIO IN port on the
Grand Ultimate Wireless. Connect the other end to the LINE OUT or SPEAKER
OUT of your sound card. On a desktop you may first have to disconnect your
existing computer speakers.
Fig. 5 – Audio Pass-Through Cable
4. Connect one of the supplied power supplies to the DC IN port on the Grand
Ultimate Wireless and then connect the supply to a wall outlet.
Fig. 6 – Audio/Video Cable
Note: Grand Ultimate Wireless also supports high quality S-VIDEO via the
S-video cable. If your TV or VCR supports S-VIDEO IN, we highly
recommend you use it to get the best TV picture. This option is not
available when transmitting the video wirelessly.
6. Toggle the display input to correspond with the video input you are using. For
instance, a TV defaults to the antenna or cable input when it is turned on. You will
see either a TV channel or snow. Each TV varies slightly, so you may need to
refer to your TV's user's manual for further assistance.
7. If you are experiencing any distortion or interference in the wireless transmission,
change the transmission channels. Using a paperclip, change the switches on
both the transmitter and the receiver so that they are on the same channel. Only
one switch should be DOWN on each and the switch that is DOWN indicates
which channel is in use.
9
10
