Grand GMD-M8, Руководство пользователя

Страница: 19 / 32

送 带 机 异 常 振 动
Vibration
送带数值
999
仍然过紧
999 still too tight
送带值
000
仍然过松
000 still too loose
送 带 机 无 动 作
No signal
萤 屏 不 显 示
Blank panel
模式数值无法记忆
Cannot memorize the Mode
启动后，松紧带无法回
拉至所设定的松紧度
After turn on the power, the
elastic tape can not pull back
to reach the setting tension.
支架各固定螺丝松弛
灵敏度值过高
1. F ixed screw loosen.
2. The value of Sensitivity is too high.
感测杆有异物接触碰撞
.
感应值不在正常范围
.
1. Something contact with the sensor bar.
2. The sensor is not at the working range.
上紧松弛螺丝
.
降低灵敏度值
,
参照第
6
页调整
.
1. Check and Tighten the screws.
2. Lower the value of Sensitivity, refer to
the page 6.
请将异物移除
.
参照第
4
页作归零校正
,
如值不在
10-90
范围内
,
通知维修人员进行更换维修
1. Remove the irrelevant object.
2. Redo the 0 kg Calibration page 4. Call the
technician to maintain if the value is not
between 10-90.
请将异物移除
.
参照第
4
页作归零校正
,
如值不在
10-90
范围内通知维修人员进行更换维修
.
1. Remove the irrelevant object.
2. Redo the 0 kg Calibration page Call the
4
technician to maintain if the value is not
between 10-90.
电源未接妥善
.
线路系统断路
.
控制系统故障
.
1. Power is not connected properly.
2. Connecting line is break.
3. Electronic control system error.
接好电源
.
检查各线路插座与插头接角是不明松脱
.
通知维修人员进行更换
.
1. Connected power
2. Check the pin of connecting plug or
socke t are not loose.
3. Call the technician to maintain.
面 板 故 障
Panel out of order.
通 知 维 修 人 员 进 行 更 换 维 修
.
Call the technician to maintain.
记忆体故障
Memory out of order.
Switches of Free Tape is not
workingproperly.
Un-plug the Switches of Free tape.
动作不正常
.
无张力开关
请拆下无张力开关的电源插头后，若可正常
回拉则表示：
无张力开关位置不良，应调整
.
If the elastic tape can pull back normally,
i t m e a n s :
1. The position of Switches of Free Tape is
not in good position, please re-adjust.
感测杆有异物接触碰撞
.
感应值不在正常范围
.
1. Something contact with the sensor bar.
2. The sensor is not at the working range.
Question phenomenon.
问题现象
Reason
原因
Countermeasure.
对策
通 知 维 修 人 员 进 行 更 换 维 修
.
Call the technician to maintain.
无张力开关故障通知维修人员进行更换维修
2. The Switches of Tape is out of order,
call the technician to maintain.
16
6
、
Send machine fault diagnosis
送带机故障诊断