Page 12
Fire Bowls and Inserts Premium Line
Automated Operation
14. Install wire nuts on wires from the control panel and burner assembly.
Be careful to hook up the “positive” to the “positive” and the “negative”
to the “negative.” Wrap wire nuts with electrical tape or some means to
prevent moisture from getting in. Make sure wire nuts are positioned at
the bottom of the bowl, away from the bottom of the burner assembly.
15. With all gas connections tight, position the burner assembly so that it
sits level in the bowl. Rotate as required so that the gas hose rests in a
compact position.
Important:
The mounting bracket must be installed for proper cooling
of the burner assembly. Warranty may be voided if the
mounting bracket is not installed. Do not kink or make sharp
radius on the metal gas hose. Do not come straight up with
the gas hose. As shown in Figure 7, a 90° gas pipe elbow
must be installed on the gas line for proper installation of
the gas hose. The product warranty may be voided if it is
not installed with an elbow as shown in Figure 7.
3/4” GAS PIPING
(UNDERGROUND)
3/4” OR SMALLER WATER LINE
10-12 GPM (UNDERGROUND)
VALVE MOUNTED W/ POOL EQUIP.
12 VAC ELECTRICAL
(UNDERGROUND)
X1
X2
1/2” KEY VALVE
WALL OR
PILASTER
MOUNTING
BRACKET
BOWL
90° ELBOW
GAS
HOSE
Figure 7. Mounting
Note:
Do not caulk or seal around the base of the Bowl (see Figure 12).
