6
5
GrandCanyonGasLogs.com
Remove all the burner components from the
burner kit and the valve control system parts from
the boxes. Locate the gas inlet on the left side of
the burner. Using a pipe wrench, rotate the gas inlet
180* degrees so that the inlet is facing the
front of the burner (this is for ALL 2-Burners,
Glass Burners, Kiva Burners, front view and see
through). For 3-Burners & Jumbo/Jumbo Slimline
Burners (front view and see through) rotate the gas
inlet 225* degrees so that the gas inlet to facing the
front of the burner pointing to the ground.
PRE-INSTALLATION
Leave the first two threads clean.
Never use compound on female threads as it
might be pushed into the control body.
6. The gas valve is multi position and can be
mounted in any position (except upside down)
without effecting its operation.
7. Install gas valve so gas flow conforms with
the inlet and outlet of the control.
8. DO NOT insert any object other than suitable
pipe or tubing in the inlet or outlet of this con-
trol. Internal damage may occur and result in a
hazardous condition. A backup wrench should
only be used on the inlet wrench boss provided
for this purpose, never on body of the control,
as this could distort the casting. NOTE: Do not
over tighten any pipe connections, as this could
crack the valve body. A valve with a cracked
valve body will not be warrantied.
INSTALLATION
