EN
User guide
6
Replacing the interior light bulb
(Fig. 11)
In case that the light bulb is out of function it is
easy to replace. First make sure that the
fridge/freezer is disconnected from the power
supply by removing the plug. Take a flat
screwdriver and keep it carefully without force into
the left gap between the lamp cover and the
internal cabinet. Then press the handle of the
screwdriver carefully to the left until you notice that
the left pin of the cover is disengaged. Repeat this
procedure on the right, but now press the handle
of the screwdriver carefully to the right side. If both
sides are loosened the cover can be removed
easily.
Ensure that the bulb is screwed securely in the
bulb holder. Plug the appliance into the power
supply. If the light is still not working, replace the
E14 screw-cap type 15 Watt (Max) bulb from your
local electrical store and then fit it. Carefully
dispose of the burnt-out light bulb immediately.
If you have changed the light bulb please fix the
cover again in its former position. Take care that
the cover closes correctly.
Cleaning and care
Interior and Exterior Surfaces
Attention
Always unplug the power cable or switch
off the circuit breaker before cleaning.
Clean the exterior by using lukewarm water and a
mild detergent.
Never use detergents, abrasive or acidic agents.
Wipe the inside compartment dry.
Be careful to prevent water from getting into
contact with the electrical connections of the
temperature control or the interior light.
If the device is not going to be used for a long
period of time, unplug the power cable and
remove all food. Clean the appliance and keep the
door open.
To preserve the appearance of your appliance,
you can polish the exterior and the door
accessories with a silicone wax.
Clean the condenser at the back of the appliance
once a year by using a brush or a vacuum
cleaner. Dust build-up leads to increased energy
consumption.
Inspect the door gasket at regular intervals.
Clean with water only, and wipe completely dry.
Cleaning of the accessories
Door shelves:
Remove all food from the door shelves.
Lift the cover of the shelf upwards and pull it off
sideways.
Remove the bottom of the door shelf by pushing it
upwards.
Collecting container (Pan):
Make sure that the pan at the back of the
appliance is always clean.
Gently release the snap of the pan from the
compressor by pushing it using a tool (like a
screwdriver), so that the pan can be removed.
Lift the pan, clean it and wipe it dry.
Re-assemble in reverse order.
Drawers:
To clean a drawer, pull it out as far as possible, tilt
it upwards and then pull it out completely (Fig. 7-
8).
Содержание KF 5326-90 FN
Страница 2: ......
Страница 6: ...1 2 KF 5326 90 FN KF 5326 90 FN X KF 5356 90 FN KF 5356 90 FN X...
Страница 7: ...3 4 5 6 8 7 9 11 10...
