Gram KF 132, Инструкция по эксплуатации

Страница: 26 / 40

26
GB
Changing the tempera-
ture
The thermostat knob setting can be changed from
1 (warmest) to 7 (coldest).
When the appliance is started the thermostat should
be in its middle setting „4”. After an hour or two the
cabinet will have cooled down. If a lower temperature
is required, turn the thermostat knob towards "7". If a
higher temperature is required, turn the knob towards
"1".
Refrigeration is switched off when the thermostat knob
setting is "0".
5
Freezing
down
Brief temperature varia-
tion
Starting up
If during transport the fridge/freezer has been laid
down, or if it has been stored in cold surround-
ings (colder than +5°C) it must be allowed to stabi-
lise for at least two hours before being switched on.
Start the fridge/freezer by plugging into a wall
socket.
Important! If the mains lead has been damaged, it
must be replaced with a corresponding type sup-
plied by Gram A/S or one of Gram's service cen-
tres.
Brief temperature variations are normal and occur
when:
-
the cabinet is filled with fresh items,
- the door is left open for longer periods.
Items of food in the cabinet will not be affected by
these variations and the temperature will quickly
return to normal.
The temperature in the freezer is closely related
to the setting in the refrigerator in cabinets with
only one compressor.
If quick freezing down is required the cabinet sho-
uld be set to run at the lowest temperature, i.e.
"7". As this setting affects both the refrigerator and
the freezer, personal experience should be used
to determine how long the quick-freeze (and thus
the low refrigerator temperature) should last. After
freezing down, the normal temperature setting
should again be chosen.
PLEASE NOTE!
Pack your frozen foods in airtight and watertight
material in order to avoid drying out. Portions
should be as flat as possible to allow rapid
freezing down.
Cleaning/defrosting
Switch off the compressor by turning the thermo-
stat knob to "0".
Cleaning the refrigerator
The refrigerator section has automatic defrosting.
The cabinet is best cleaned with a weak soap so-
lution and a soft cloth. Never use cleaning agents
that scour. Clean the sealing strip around the door
regularly to prolong its life. Use only water to clean
the sealing strip. Any loose frost on the evapora-
tor can be removed using a plastic or wooden
scraper. Never use a knife or a sharp object, as
these can damage the evaporator.
The plastic parts of the cabinet will not withstand
boiling water (max. 85°C).
Clean the defrost water drain with the accompa-
nying cleaning implement.
6