7
Hawkeye
®
Pro Videoscope
–
Connections
Input / Output Connections
Hawkeye
®
Pro Videoscope
–
Setup
Install SD Memory Card
Insert the SD Memory Card into its slot
as shown. Make sure the gold
contacts are facing away from the
video display screen as shown in the
photo. Push the card in gently, as far
as your finger will allow, and release.
DO NOT FORCE THE CARD INTO ITS SLOT
WITH THE CONTACTS FACING THE WRONG
DIRECTION
. The card will remain in place. To remove the card, push it in a
little and release. It will spring out far enough to grasp and remove.
Caution -
Do not remove the SD memory card during image capture
operations, data will be lost and the memory card may be damaged.
The video display shows live video and captured still or moving images.
It can output live video to an external monitor via a composite signal
connector and the included cable.
Stored images can be downloaded to a computer via the USB port and
included cable, or through the removable SD memory card.
SD Memory Card Slot
Composite Video Out
Charger Input
USB Out
8
Hawkeye
®
Pro Videoscope
–
Setup
Install 90-degree Prism Tip
If the 90° Prism Tip is needed:
Remove the Tip Cap.
Always keep the Tip Cap or an adapter installed to protect the Tip threads.
Notice the locating flat on the scope tip.
Thread the knurled portion of the Prism Tip on, just past the first set
of threads on the Tip.
Rotate the Prism Tip until its internal flat engages the locating flat on the
scope tip. Then continue threading the Prism Tip on until there is no side-
play in the Prism Tip. STOP threading at that point.
FINGER-TIGHTEN ONLY
OR DAMAGE MAY RESULT.
A small gap will be present when Prism Tip is fully tightened in place.
Do not force beyond this point.
No side play.
